The Ranking
Our top 7 restoration companies in Phoenix
Most restoration calls in Phoenix start with water, but rarely from rain alone. A failed water heater in the garage, a cracked supply line under a sink, an air conditioner condensate line overflowing in the attic or a slab leak under tile are the losses crews see week in and week out. Then the monsoon arrives, usually from mid June through September, and brings dust storms, sudden downpours, flash flooding in washes and low streets, and roof leaks on homes whose flat roofs or tile underlayment have baked for years in the sun. Fire and smoke work follows kitchen fires and summer brush fires on the edges of the Valley.
Speed matters. Drywall, baseboards and cabinets wick water fast, and mold can start growing within a day or two in a closed, humid wall cavity even in a dry climate. Good crews follow the IICRC S500 standard for water damage and S520 for mold: they find the source, extract standing water, measure moisture with meters, set air movers and dehumidifiers, and keep a written drying log until readings reach a dry standard. Ask for those readings. They are your proof to the insurer that the house was actually dried.
On insurance, a standard homeowners policy usually covers sudden and accidental water, such as a burst pipe, but not slow leaks that went on for months, and it usually excludes surface flooding unless you carry a separate flood policy. Most companies here will bill your insurer directly, leaving you to pay the deductible and anything the policy denies. You can choose your own contractor even when the insurer recommends one, and you should get the mitigation estimate and the rebuild estimate as separate documents.
For licensing, the Arizona Registrar of Contractors licenses the repair and rebuild side of the work. Look up any ROC number on the registrar's contractor search before you sign, and check the classification and any complaints. We did not find a separate Arizona state licence for mold remediation, so IICRC training such as WRT for water, FSRT for fire and AMRT for mold is the best check for that part of the job. Two companies on this list publish no ROC number, and we say so in their profiles.