The Ranking
Our top 7 fence companies in Chicago
A fence in Chicago has to survive the ground before it has to survive anything else. Much of the city sits on old lake-bed clay that holds water, and every winter that wet soil freezes, swells and lets go again. Posts set too shallow or without concrete start to lean after a few freeze and thaw cycles, and gates sag first. Ask every company how deep it sets posts and gate posts; Fence for Sure, for example, says it sets posts at least 36 inches deep in concrete. Steel posts behind cedar boards have become common here because wood posts rot fastest right at the wet clay line.
Weather and city life add their own wear. Wind off the lake pushes hard on long solid privacy runs, plows pile salty snow along alleys and parkways, and road salt eats at iron and steel that is not kept painted. Cedar privacy fences on steel posts are the usual backyard choice, vinyl has grown popular for owners who never want to stain again, chain link still lines a lot of alleys and dog runs, and ornamental iron or aluminum is the classic front fence for bungalows, greystones and two-flats. Older iron can usually be repaired, repainted or matched with a new gate rather than replaced.
Licensing works differently in Chicago than in most of the country. Illinois has no statewide licence for general contractors or fence builders, but the City of Chicago Department of Buildings licenses general contractors in classes tied to project size, and a contractor who pulls a city building permit must hold that licence. Ask for the licence and a certificate of insurance, and do not let a contractor talk you into pulling an owner permit for work they will do. Suburbs set their own registration rules, so a company licensed in Oak Park or Cicero is not automatically covered in the city.
Permits follow height and placement. Under the city's rules as local fence companies summarize them, a fence 5 feet tall or under generally needs no building permit but must still meet zoning, and a fence over 5 feet generally needs one, often through the city's Express Permit Program. Side and rear yard fences on residential lots are generally capped at 6 feet. Inside a required front setback, a fence that is more than 20 percent solid is generally limited to 54 inches, while an open design such as iron pickets can reach 6 feet. Corner lots, alley entrances, landmark districts and pool barriers carry extra rules, and condo associations often have their own approval steps, so confirm the details with the Department of Buildings or your installer before you sign.
Before anyone digs, call for a utility locate. Inside Chicago city limits that request goes to Chicago 811, the city's system once known as DIGGER, and everywhere else in Illinois it goes to JULIE. Plan on at least two working days of notice, and remember that private lines such as a garage feed are not marked by either. Property lines matter too: use a current plat of survey, do not assume an old fence marks the line, and talk to the neighbor before a shared alley or side-lot fence goes up. If you have a pool, the barrier and its self-closing, self-latching gates must meet code, and the installer should confirm the design. This list runs from the Northwest Side to Clearing on the Southwest Side and the North Avenue iron shops, so you can match the company to the job.